Checking The Oil Automatic System; Changing The Saw Bar; Fitting The Saw Chain; Sawing.techniques - FLORABEST FKS 2200 C2 Betriebsanleitung

GB
Checking the oil automatic
system
Check the oil level and the automatic oil
system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chainsaw is
working trouble-free.
If no oil trace can be seen clean the
oil passages or turn the chainsaw
to our Service-Center for repair.
J 4. Clean the oil passages of the
chain bar (25), in order to guar-
antee a trouble-free, automatic
oiling of the saw chain during
operation.

Changing the saw bar

1. Switch the saw off and unplug it
F
from the mains.
2. Lay the saw on a flat surface.
3. Turn the fastening bolt (14) anti-
clockwise and loose the chain
adjustment ring (
the sprocket chain wheel cover-
ing (15).
4. Remove the saw bar (4) and saw
chain (
A
bar (4), raise it to an angle of ap-
prox. 45 degrees. This will make
it easier to take the saw chain (5)
off the sprocket
5. To fit the new bar, place the bar
(4) onto the bar bolt (21) with
the tensioning plate pointing out-
wards (22).
62
13) to remove
A
5). To remove the guide
( 23).
G

Fitting the saw chain

1. Switch the saw off and unplug it
G
from the mains.
2. Spread the chain (5) out into a
loop with the cutting edges run-
ning clockwise .
3. Slide the saw chain (5) into the
bar guide groove. To mount the
guide bar (4), raise it to an angle
of approx. 45 degrees. This will
make it easier to replace the saw
chain (5) onto the sprocket (23).
It is normal that the saw chain (5)
is slack. Sagging in the chain is
normal.
4. Pre-tighten the chain (5) by turn-
ing the tensioning plate (22)
clockwise.
5. Position the sprocket chain wheel
covering (15). First place the tab
(24) on the cover into the corre-
sponding notch on the plate (15).
Only lightly tighten the fastening
bolt (14), as you will still have to
tension the saw.
Refer to the start-up section on how
to tension the saw chain.
Sawing techniques

General

• You have better control when you saw
with the bottom side of the chain bar
(with pulling saw chain) and not to with
the top side of the chain bar (with push-
ing saw chain).
• The saw chain must not contact either
the ground or another object during
sawing through or after sawing comple-
tion.