How To Use The Ait Auto Loader Unit - Sony TSL-SA400C Bedienungsanleitung

How to Use the AIT Auto Loader Unit

36
Chapter 3 Operation
1
Press the POWER switch on the rear panel.
The power turns on and the POWER indicator lights.
Self-testing starts: the BUSY indicator and the TAPE indicator should
each light briefly.
2
After the two indicators turn off, insert a magazine.
3
Be sure to push the cartridges all the way into the magazine. If the
cartridges are not pushed in all the way, the hook on the magazine
protrudes outward, and will prevent magazine insertion into the
Autoloader.
Good
Hook not protruding
When the magazine is loaded, the following actions occur:
• After "Magazine Loading" appears, checking of the magazine starts.
• If the magazine is write-protected, the write-protect indicator (
• All cartridges are checked in order.
• As each cartridge is checked, its number blinks.
4
"Scan4 Ok" should be displayed, when all cartridge numbers display on
the LCD, a cartridge to be loaded into the AIT drive may be selected by
computer software or by the SELECT or ENTER buttons on the
machine. When a cartridge is loaded into the AIT drive, the TAPE
indicator lights.
5
Data may be read or written on the tape using computer software. While
reading or writing, the BUSY indicator lights.
Bad
Hook protruding
Inserting the magazine
Hook protruding
) appears.