Inhaltsverzeichnis
Werbung
SCSI ID Setting
28
Chapter 2 Preparation
The SCSI ID is set by the rotary switch on the rear panel. Press the + or -
buttons to move the number up or down, respectively.
As shipped from the factory, the SCSI ID is set to 0. Press the switch buttons,
if necessary, to select the SCSI ID number you require. SCSI IDs above 9 are
displayed as A to F (hexadecimal). Usually 7 is reserved for the host adapter
ID, and should not be selected for other devices.
Precautions:
• The SCSI ID must be different from IDs of the other peripherals on the
SCSI bus.
• As shipped from the factory, SCSI parity is enabled and Term power is ON.
Since the terminating resistor inside the drive is disabled, a SCSI bus
terminator must be connected to the SCSI bus before use.
• Before changing the SCSI ID setting, be sure to turn off the power with the
POWER switch on the rear panel.
Werbung
Kapitel
Inhaltsverzeichnis
