Fitting and Adjustment
Auto Level Adjustment
The auto level adjustment is necessary to ensure that the video
levels are appropriate. Carry out auto level adjustment in step 6
(page 15) of the procedure under "Fitting and Adjustment".
1
2
3
• If the indicator lights in red, check the switch setting on the
• The adjustment values are stored on this board, so
For details of the operating procedures for other devices, refer to the
operating instructions supplied with each device.
16
Power on the CCU-TX7/TX7P, CA-TX7/TX7P, and
camera.
On the RCP-TX7 or COU-TX7/TX7P select "BARS".
Color bars appear in the monitor or viewfinder.
With a pen or other sharp implement, press the AUTO
LEVEL switch.
After a few seconds, when the AUTO LEVEL indicator
lights in green the auto level adjustment is completed.
Notes
board. (See step 1 on page 13.) If the indicator flashes, check
that color bars are being displayed.
readjustment is not normally required.
However, if the CCU-TX7/TX7P is not used for a long time
(several months), or if the board is installed in a different
CCU-TX7/TX7P, the auto level adjustment must be made
again.