Conrad F 113 Bedienungsanleitung Seite 5

5. Clamp-opening lever for opening/closing the clamp-on
ammeter
6. Measurement range switch for switching the measuring
device ON/OFF, and also for activating the following measu-
rement functions:
400 A 400 A DC/AC current measurement range (no Auto-
Range = automatic range selection = AR)
1000 A 1000 A DC/AC current measurement range, no AR
400 V 400 V DC/AC current measurement range, no AR
600 V 600 V DC/AC current measurement range, no AR
400 Ω 400 ohms resistance measurement range, no AR
acoustic continuity check, acoustic signal with
through resistances of less than 15 Ω
kHz frequency measurement range incl. AR:
40 kHz, 400 kHz and 4 MHz
7. Switch in „OFF" position: In this position the measuring
device is deactivated
8. „DCA ZERO ADJ" button for setting to zero in DC current
measurement (DCA)
3
/
9. 3 digit LCD (liquid crystal display) Display 3999 max.
4
10. „DC/AC" slide switch for switching from DC current or volta-
ge measurement (DC) to AC current or voltage measure-
ment (AC)
11. COM socket or „−" = minus terminal for the black measuring
lead (common = ground)
12. Warning: MAX 600 V
exceed 600 V.
8
4 kHz,
Voltage to earth must never
13. VΩHz socket or „+" = plus terminal for the red measuring
lead (all measurements except current)
Key to display symbols
14
15
AC
16
17
18
14. „Peak Hold". Displayed when (yellow) „HOLD" button is
pressed.
15. „AC". AC signifies alternating voltage or current.
16. „−". Polarity display. A „−" in front of the measurement
value signifies negative polarity. No „−" in front of the mea-
surement value signifies positive polarity.
17. Buzzer. A piezo disk inside the housing transmits acoustic
signals as soon as the through resistance is or 15 Ω less
during the continuity check.
18. „BAT". Displayed if the battery needs replacement.
19. „0L". OL signifies overload.
19
9