Maintenance; Ordering Replacement Parts - EINHELL KGS 190 Bedienungsanleitung

Anleitung KGS 190
Re-tighten the counter nut (30) to fix the machine
in this setting.
H.) Mitre cuts 0°-45° and rotary table 0°-45°
(Fig. 10)
The KGS 190 can be used to make mitre cuts on the
left at an angle of 0°-45° relative to the work top and
0°-45° relative to the stop rail.
Lift the machine head (4) to its top position.
Undo the rotary table (8) by slackening the two
lock screws (10) on the stop rail.
Adjust the rotary table (8) by its handle (2) to the
required angle (see also Section E).
Re-tighten the two lock screws (10) to fix the
rotary table in position.
Undo the clamping screw (13) and tilt the
machine head (4) by its handle (2) to the required
angle dimension (see also Section F).
Re-tighten the clamping screw (13).
Make the cut as described in Section C.
I.) Chip extractor (Fig. 2)
The saw is equipped with a chip extraction socket
(18).
It is easy therefore to connect the machine to a chip
extraction system.
J.) Replacing the saw blade (Fig. 11)
Pull out the power plug.
Swing up the machine head (4).
Unscrew the 4 recessed head screws (17) and
take off the left saw blade cover (15).
Use the supplied face wrench (11) to lock the
outer flange (a) in place and use the socket
wrench (12) to unscrew the hex screw
(Important: left-hand thread. Unscrew
clockwise!).
Take the saw blade (5) off the inner flange and lift
up and out.
Mount the new saw blade in reverse order and
fasten.
Important! The cutting bevel of the teeth, i.e. the
direction of rotation of the saw blade, has to
conform with the direction of the arrow marked on
the housing.
Clean the saw blade flanges thoroughly before
mounting the saw blade.
Before using the saw again, check that the safety
devices are in good working order.
30.10.2001 9:23 Uhr Seite 15

8. Maintenance

Keep the machine's air vents unclogged and
clean at all times.
Remove dust and dirt regularly from the machine.
Cleaning is best done with compressed air or a
rag.
Re-lubricate all moving parts in regular intervals.
Never use caustic agents to clean plastic parts.

9. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
GB
15