Cleaning; Troubleshooting - Silvercrest SKD 2300 A1 Bedienungsanleitung

RP90866 Konvektor LB6so Seite 10 Dienstag, 2. Juli 2013 3:39 15
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
Fault
Appliance cannot be Faulty fuse or wall socket
switched on
Faulty appliance
Appliance switches Thermal cut-out has
off automatically triggered
Only cold air is pro- Selected temperature has
duced been reached
10

7. Cleaning

2. Remove any remaining dirt with a soft
brush.
3. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth
moistened with clear water.
5. Do not use the appliance again until it
has dried completely.

8. Troubleshooting

Cause
Select another wall socket
Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
"Service Centre" on page 13.
Allow the appliance to cool down (see
"6.5 Thermal cut-out" on page 9)
Clean the appliance (see
"7. Cleaning" on page 10)
Appliance switches on again automati-
cally as soon as the room temperature
falls
Select a higher desired temperature
Remedy