Inserting The Batteries; Operating; Using The Appliance For The First Time; Selecting The Temperature - Silvercrest SKD 2300 A1 Bedienungsanleitung

RP90866 Konvektor LB6so Seite 8 Dienstag, 2. Juli 2013 3:39 15
1. Select a location in compliance with the
safety information
information" on page 4).
2. Plug the mains plug into a wall socket
that complies with the technical data.
Note:If you have plugged other power
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.

5.3 Inserting the batteries

If the appliance is new or the batteries in the
remote control are flat, new type AAA/
LR03 batteries must be inserted.

6.1 Using the appliance for the first time

1. Plug the mains plug into a wall socket
that complies with the technical data
(see "3. Technical data" on page 4).
2. Switch the mains switch 9 to "I" to
switch on the power supply.
The lamp in the main switch 9 lights up
and you hear a beep.
3. Press the On/Off button 22 to switch
the appliance on.
The display 5 lights up.
The appliance is now ready for use and can
be operated by means of the remote control
or control panel 2.
8
1. Push off the battery compartment cover
(see "4. Safety
2. Remove the old batteries if present.
3. Insert new batteries.
4. Close the battery compartment again.

6. Operating

6.2 Selecting the temperature

Notes:
• Temperature display 20:
• Temperature display 21:
• Temperature is measured directly at the
1. To choose whether you wish the
2. Press
on the underside of the remote control.
Note: Please observe the instructions
for disposal (see "9.2 Disposable/
rechargeable batteries" on page 11).
Note: Ensure the correct polarity (+/
–). The correct polarity is shown on the
bottom of the battery compartment.
– set specified temperature
– measured actual temperature
appliance using temperature sensor 8. It
may be some time before the entire
room has also reached this temperature.
temperature to be displayed in °C or °F,
press button 24.
Selected unit of measurement 14 is
shown in the display 5.
the "Increase
button 16 to increase the desired
temperature up to a maximum of 37 °C
(99 °F).
Selected specified temperature 20 is
shown in display 5.
temperature"