Cleaning; Troubleshooting - Silvercrest SWW 1500 B2 Bedienungsanleitung

CPE100696 Wärmewelle LB1 Seite 51 Donnerstag, 26. Juni 2014 4:51 16
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning! To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
Fault
Appliance cannot be
switched on
Appliance switches
off automatically
Appliance does not
heat
SWW 1500 B2

7. Cleaning

8.

Troubleshooting

Cause
Faulty fuse or wall socket
Faulty appliance
Thermal cut-out has
triggered
Selected temperature has
been reached
1. Carefully remove major dust deposits
with a vacuum cleaner.
2. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution! Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
3. Wipe the appliance with a cloth
moistened with clear water.
4. Do not use the appliance again until it
has dried completely.
Remedy
Select another wall socket
Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
"Service Centre" on page 53.
Allow the appliance to cool down (see
"6.4 Thermal cut-out" on page 50)
Clean the appliance (see
"7. Cleaning" on page 51)
Heating switches on again automati-
cally as soon as the room temperature
falls
Select a higher required temperature
51