Eccentric Screws; Sawing (Without Guide Rail); Sawing (With Guide Rail) - Parkside PTSS 1200 A1 Originalbetriebsanleitung

Eccentric screws

The eccentric screws
the fit of the base plate
♦ Tighten the eccentric screws
play between the circular saw and the guide
rails .

Sawing (without guide rail)

Right-angled sawing
♦ Hold the machine with both hands firmly on the
handles and .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Place the appliance with the front part of the
base plate on the workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Mitre angles up to 45°
♦ Adjust the cutting angle and cutting line as
described.
♦ Hold the machine with both hands firmly on the
handles and .
♦ Switch on the appliance as described in "Switch-
ing on and off". Place the appliance with the front
part of the base plate
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Plunge cuts
♦ When making a "plunge cut" which is not at
right angles, secure the base plate of the saw to
prevent any lateral movement. Lateral movement
can cause the saw blade to jam, thus causing
a kickback.
♦ Adjust the desired cutting depth as described
above.
♦ Place the appliance on the workpiece.
♦ Avoid kickback and place the rear edge against
a stop (as referenced in the section "Plunge
cutting with guide rail").
♦ Switch on the appliance as described in
"Switching on and off".
PTSS 1200 A1
are intended for adjusting
on the guide rail .
to reduce the
on the workpiece.
♦ Hold the machine with both hands firmly on the
handles and and pivot it.
NOTE
► The cut width marking
blade guard shows the front and rear cutting
point of a 165 mm at maximum cutting
depth. This applies both to plunge cuts with
guide rail and plunge cuts without guide
rail .

Sawing (with guide rail)

Right-angled sawing with guide rail
♦ Place the guide rail
element on the workpiece.
♦ Place the appliance with the groove
guide rail .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and and pivot it.
Mitre angles up to 45°
♦ Apply the guide rail
element onto the workpiece.
♦ Place the appliance with the groove
guide rail .
♦ Adjust the cutting angle and cutting line as
described.
♦ Hold the machine with both hands firmly on the
handles and .
♦ Switch on the appliance as described in
"Switching on and off". Place the appliance
with the front part of the base plate
workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
on the side of the
with the foam rubber
onto the
with the foam rubber
onto the
on the
GB
IE
9