Before Fi Rst Use; Assembling/Dismantling The Appliance - Silvercrest SGP 28 A1 Bedienungsanleitung

Before fi rst use
GB

Assembling/dismantling the appliance

8
♦ Clean all accessories as described in the chapter "Cleaning" to remove any
possible production residues.
DANGER
Remove the plug of the power cord 3 from the mains socket before assembling
the appliance components.
Flip the handle 2 90° from the motor unit 4 until it clicks into place.
♦
Inserting the threaded rod with pusher
1) Place the end of the threaded rod 5 into the motor unit 4. Ensure that
the pins on the inside of the motor unit 4 grip into the guide rail of the
threaded rod 5.
2) Push the threaded rod 5 with the pusher 6 as far as it will go into the
motor unit 4.
Attaching/removing the container
NOTE
The container 7 must be attached otherwise the biscuit shaper will not function!
1) Push the container 7 over the pusher 6 such that the guide rails inside
the container 7 engage in the in notches on the pusher 6.
2) Place the container 7 on the motor unit 4 so that the arrow on the con-
tainer 7 points to the
3) Turn the container 7 until this arrow points to the
unit 4.
To remove the container 7, turn it until the arrow on the container 7 points
mark on the motor unit 4. Now you can remove the container 7.
to the
marking on the motor unit 4.
marking on the motor
SGP 28 A1