Cleaning The Rinsing Pump; Replacing The Rinsing Pump - Oase ProfiClear Premium Gebrauchsanleitung

- GB -
Fitting
How to proceed:
8.
U
Prior to installing the filter drum, please check that the drum sealing ring is in perfect condition and in the
correct position. Replace the drum seal, if damaged.
1. Insert a new drum sealing ring. The recess in the drum sealing ring must point upwards.
2. Ensure that the separating plate is completely seated in the groove of the drum seal.
3. Grease the drum edge, this will improve the smooth movement of the filter drum.
Only use original grease from OASE.
−
T
Fit in the reverse order.
►
9.6

Cleaning the rinsing pump

It is often possible to remove soiling from the rinsing device and rinsing pump by cleaning the rinsing
device without the nozzles. (
Remove all the nozzles for cleaning so that the dirt particles are flushed out.
►
Remove the filter drum to allow work to be carried out on the rinsing pump. (
How to proceed:
4.
V
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Lift the rinsing pump, remove the rubber ring and filter sock.
Clean all parts in clean water.
−
9.7

Replacing the rinsing pump

Remove the filter drum to allow work to be carried out on the rinsing pump. (
How to proceed:
3.
W
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Loosen the hose clip and pull off the hose.
3. Take out the rinsing pump and replace.
Disconnect the connection cable from the cable harness.
−
4. Fit the rinsing pump in the reverse order.
66
30648-08-13_GA_ProfiClear_Premiu66 66
Cleaning the rinsing device)
Removing the filter drum)
Removing the filter drum)
21.08.2013 10:23:05