Correct Electrical Installation; Safe Operation - Oase ProfiClear Premium Gebrauchsanleitung

4.3

Correct electrical installation

Electrical installations must meet the national regulations and may only be carried out by a qualified
►
electrician.
A person is regarded as a qualified electrician, if, due to his/her vocational education, knowledge
►
and experience, he or she is capable of and authorised to judge and carry out the work
commissioned to him/her. This also includes the recognition of possible hazards and the adherence
to the pertinent regional and national standards, rules and regulations.
For your own safety, please consult a qualified electrician.
►
The unit may only be connected when the electrical data of the unit and the power supply coincide.
►
The unit data is to be found on the unit type plate or on the packaging, or in this manual.
Ensure that the unit is fused for a rated fault current of max. 30 mA by means of a fault current
►
protection device.
Extension cables and power distributors (e. g. outlet strips) must be suitable for outdoor use.
►
Ensure that the power connection cable cross section is not smaller than that of the rubber hoses
►
with the identification H07RN-F. Extension cables must meet DIN VDE 0620. requirements
Protect the plug connections from moisture.
►
Only plug the unit into a correctly fitted socket.
►
4.4

Safe operation

Never operate the unit if either the electrical cables or the housing are defective!
►
Do not carry or pull the unit by its electrical cable.
►
Route cords/hoses/lines in a way that they are protected against damage, and ensure that they do
►
not present a tripping obstacle.
Only open the unit housing or its attendant components, when this is explicitly required in the
►
operating instructions.
Only execute work on the unit that is described in this manual. If problems cannot be overcome,
►
please contact an authorised customer service point or, when in doubt, the manufacturer.
Only use original spare parts and accessories for the unit.
►
Never carry out technical modifications to the unit.
►
The power connection cables cannot be replaced. When the cable is damaged, the unit or the
►
component needs to be disposed of.
Keep the socket and power plug dry.
►
Overvoltage in the mains could lead to operating malfunctions of the unit. For information, please
►
refer to chapter "Remedy of faults".
Do not breath in the spray from the rinsing device. The spray may contain harmful bacteria. When
►
the container cover is lifted up, the rinsing device continues operating.
30648-08-13_GA_ProfiClear_Premiu45 45
- GB -
45
21.08.2013 10:23:04