Cleaning The Screen Element; Removing/Fitting A Screen Element; Decalcifying The Screen Elements; Removing/Fitting The Filter Drum - Oase ProfiClear Premium Gebrauchsanleitung

9.4

Cleaning the screen element

9.4.1

Removing/fitting a screen element

How to proceed:
4.
S
Removing
1. Turn the filter drum manually until the screen element is at approx. ten o'clock. Undo both locking
mechanisms (turn through 180°).
2. Lower the screen element completely into the filter drum.
3. Remove the screen element from the filter drum.
Fitting
4. Lower the screen element completely into the filter drum.
5. Turn the screen element and push the two hinges onto the support of the filter drum.
6. Pull the screen element upwards by the locking mechanisms.
Ensure that the pin on the filter drum exactly engages in the recess on the side of the screen
−
element.
7. Close both locking mechanisms (turn through 180°).
9.4.2

Decalcifying the screen elements

The error messages
that there are limescale deposits on the screen elements. (
cycles)
Oase recommends that you descale the unit every two to three months as a preventative measure if the
water is very hard.
How to proceed:
8.
1. Remove a screen element. (
2. Fill a container with water, add commercially available descaler for coffee machines (follow the
manufacturer's instructions) and immerse the screen element in the solution.
Do not remove the rubber seal of the screen element.
−
3. After a sufficient application time, scrub the screen element with a soft brush under running water
and rinse well.
4. Refit the screen element. (
9.5

Removing/fitting the filter drum

Remove a screen element to allow work to be carried out inside the filter drum. (
element)
Removing
How to proceed:
5.
T
1. Pull the rinsing device out of the fastening clips and separating plate, and hang it over the edge of
the container.
2. Undo and remove both Allen screws (width across flats 5), pull the drum motor out of the hole in the
separating plate and remove.
Do not allow the drum motor to hang from the connection cable.
−
3. Undo the hose clip fastening the dirt channel.
4. Pull the dirt channel from the socket of the dirty water outlet and take it out of the filter drum.
5. Open the cotter pin and pull it out.
6. Pull out the drum shaft.
7. Pull the filter drum from the separating plate and lift it out of the container.
Proceed carefully: The fastening clips on the container wall could damage the screen elements.
−
30648-08-13_GA_ProfiClear_Premiu65 65
3 , 5 or an excessive rise in the frequency of cleaning cycles (counter) indicate
E E r r 3 3 3 E E r r 5 5 5
Removing/fitting screen elements)
Removing/fitting screen elements)
Reading out the number of cleaning
Replacing a screen
21.08.2013 10:23:05
- GB -
65