Auerswald COMmander 6000R Xtension Installationsaleitung Seite 13

Connecting the Expansion Power Supply Unit
Note: Make sure that all cables are laid behind the mounting rail for the expansion circuit board.
1. Connect the 230 V power cable (1) with the expansion power supply unit.
2. Connect the 230 V power cable (2) of the expansion power supply unit with the access of the base
power supply.
3. Connect the control cable (3) of the expansion power supply unit with the access of the base power
supply.
Warning: Improper handling of the device can result in life-threatening electric shocks.
• Make sure the polarity is correct when connecting the 230 V power cable to the power unit.
• Check the safety of the device in accordance with EN 62638.
yellow
Ä
~
Å
brown
blue