CO/Tech RT150/1 Bedienungsanleitung Seite 6

2. Features
1. Router tabletop
2. Table extension (2 pcs): Provide extra support for long workpieces.
3. Legs (4 pcs)
4, 5, 6, 7 and 8. Table insert (5 pcs) for variable spindle opening. Use the table insert which is just larger than
the outside diameter of the cutter bit so as to utilize the suction of the dust extractor as much as possible.
9. Clamp (4 pcs)
10. Combination circuit breaker: On/off, No Volt Release switch
11. Guide fence: Adjustable for different workpieces
12. Adjustable fence for 11
13. Dust hood: Transparent guard so you can see the cutting operation
14. Spring
15. Washer
16. Bolt
17. Tri-star knob for fence (small)
18. Tri-star knob (large, 2 pcs)
20. Dust extraction port insert
21. Mitre guide slider
22. Mitre guide
23. Tri-star knob (small)
24. Hex nut (M5)
25. Dust extraction port
26. Bolt (M5)
28. Washer
29. Router fastening bolt (M5)
30. Washer
31. Guide fence bolt (M6 × 40 mm, 2 pcs)
32. Mitre guide bolt
33. Guide fence bolt (M6 × 25 mm)
34. Washer
35. Wing nut
36. Washer
37. Coach bolt M6 × 40 mm
38. Featherboard (3 pcs): Adjustable, for holding the workpiece against the table/fence.
39. Adjusting knob
40. Washer
41. Bolt (M6 × 30 mm)
6