Remove Blockages; Storage; Disposal - AL-KO HW 600 ECO Betriebsanleitung

GB
7.3

Remove blockages

1. Disconnect the pump from the mains supply
and secure to prevent restarting.
2. Disconnect suction line from pump inlet.
3. Connect pressure line to the water line.
4. Allow water to run through the pump housing
until the blockage is removed.
5. Switch on the pump briefly to check whether
it runs smoothly.
6. Put the pump into operation as described.

8 STORAGE

1. Drain suction line (16) and pressure line (10).
2. Unscrew drain plug (8) and allow the water to
drain out of the pump. The water in storage
vessel (6) is forced out at the same time by
the air bellows.
3. Screw in drain plug (8) again and store pump
and accessories in a frost-proof place.
NOTE
If there is the danger of frost, the system
must be completely drained and the
pump must be stored in a frost-proof
place.

9 DISPOSAL

Electrical and electronic appliances do not
belong in household waste, but should be
collected and disposed of separately.
The packaging, device and accessories are
made of recyclable materials, and must be dis-
posed of accordingly.
24 HW 600 ECO | HWI 600 ECO
Storage