Operation - Kärcher BR/BD 530 Bp Betriebsanleitung

 Remove battery plug and join it to the
charging cable.
 Connect the charger to the mains and
turn it on.
Low maintenance batteries (wet batter-
ies)
 Add distilled water one hour before the
charging process comes to an end; fol-
low the correct acid level. There are
corresponding indicators on the battery.
Danger
Danger of causticization!
Adding water to the battery in its dis-
–
charged state can cause the acid to
leak.
Use safety glasses while handling bat-
–
tery acid and follow the safety instruc-
tions to avoid personal injury or damage
to clothes.
Should the acid spray on to the skin or
–
clothes, rinse immediately with lots of
water.
Caution
Risk of damage!
Use only distilled or desalinated water
–
(EN 50272-T3) for filling the battery.
Do not add any substances (so-called
–
performance improving agents), else
warranty claims will not be entertained.
Recommended batteries
Manufactur- Description
er, Kärcher
order no.
DETA 12 V GIS 80, mainte-
6.654-097.0 nance-free, capacity: 80
Ah, voltage: 12 V
DETA 12 V GIS 75 DT, mainte-
6.654-093.0 nance-free, capacity: 75
Ah, voltage: 12 V
HOPPECK 12 V / 70 Ah, mainte-
E nance-free, capacity: 70
6.654-224.0 Ah, voltage: 12 V
24
Recommended chargers
Manufactur-
er, Kärcher
order no.
KÄRCHER
6.654-102.0
KÄRCHER
6.654-067.0
Batteries and chargers are available in spe-
cialised stores.
Warning
Only use maintenance-free batteries while
replacing batteries in package appliances.
Battery control display
The charging status of the battery is shown
in the display on the operations panel:
After switching on the button for brush
–
operations or suction turbine, the oper-
ating hours are displayed for 5 seconds.
A bar diagram is then displayed to show
–
the charging status of the battery.
Removing the batteries
 Switch off the button for brush opera-
tions and suction turbine
 Release the lock screw for the contain-
er and open the container.
 Clamp off the minus pole of the battery.
 Clamp off the remaining cables from the
battery.
 Remove the batteries.
 Dispose of the used batteries according
to the local provisions.
Caution
Risk of damage. Raise the vacuum bar be-
fore reversing.
Note
The appliance is designed and built in such
a way that the brush head is projecting to-
wards the right. This enables working in a
comfortable way close to the edges.
– 6
EN
Description
Separate charger for bat-
tery 6.654-093.0
Separate charger for bat-
tery 6.654-097.0

Operation