Timer Mode - Grundig WTR 3000 BT Bedienungsanleitung

TIMER­MODE
Setting­the­alarm­times­and­mode
Note:­
You can select the »Alarm
7
menu also by pressing and holding down
»Mode/AL« in stand by mode.
1
Press »ON/OFF« to switch on the device.
2 Open the menu with »MENU«.
3
Select the option »System
­
with » « and confirm by pressing »OK/i«.
r e
4 Select the option »Alarm« with »
confirm by pressing »OK/i«.
– Display: »Alarm1« and »Alarm2« flash.
5 Select the option »Alarm1« with left and right
button and confirm by pressing »OK/i«.
– Display: »Alarm 1 Info«.
6
Activate the alarm stand-by with »
(»Alarm On«) and confirm by pressing
»OK/i«.
– Display: »Alarm On«.
7 Set Wake Up time with with left and right sym-
bol and confirm by pressing »OK/i«.
8
Set the hours with »
ing »OK/i«.
9
Set the minutes with »
pressing »OK/i«.
10­ Select »Alarm source« ( ""Beep" = sig-
nal tone) or »FM« = FM station) with »
and confirm by pressing »OK/i«.
Note:
If the alarm is set to »FM«, it will be the last
7
listened station when alarm.
11­­ S elect the alarm volume with »
firm by pressing »OK/i«.
– Display: »Volume 9«.
12­­
S et initial alarm volume with left and right sym-
bol and confirm by press »OK/i«.
13­­
P ress »Menu« to end the setting.
– Display: »e«.
12­ ­ ENGLISH
­--------------------------------------------------------------------------------------------------------------------------
Setup«
Settings«
­ « and
r e
r
­
« and confirm by press-
r e
­
« and confirm by
r e
­ « and con-
r e
Interrupting­the­alarm
1 Press »OK/i« while the alarm is sounding.
– Display: »Alarm« flash.
– The alarm (signal tone or radio) stops.
Note:
The alarm will sound again depending
7
on how often a button has been pressed
(1 time = after 5 minutes, 2 times = 10 min-
utes, 3 times = 15 minutes, 4 times = 20
minutes, 5 times = 25 minutes, 6 times = 30
minutes. The total alarm time is 30 minutes.
Cancelling­alarm­stand-by
1
Press »ON/OFF« while the alarm is sounding.
– Display: the current time and alarm.
– The alarm (signal tone or radio) stops, but the
alarm function remains activated for the next
day at the same time.
­
«
e
Activating­and­deactivating­the­
alarm
1
Press »ON/OFF« to switch off the device.
2 Press »Mode/AL« to deactivate or reactivate
the alarm stand-by.
Note:­
1 time = alarm1 On, 2 times = alarm 1 On
7
and alarm 2 On, 3 times = alarm 1 Off and
alarm 2 On, 4 times = alarm 1 Off and
alarm 2 Off.
«
r e