Radio Mode; General Functions; Listening­to­an­external­source - Grundig WTR 3000 BT Bedienungsanleitung

RADIO­MODE
General­functions
Switching­on­and­off
1 Press »ON/OFF« to switch the device on and
off.
Adjusting­the­volume
1 Rotate volume knob to adjust the volume.
Adjusting­the­tone
1
Open the menu with »Menu«.
2 Select the option »System
with » ­ « and confirm by pressing »OK/i«.
r e
3
Select the
­
» « and confirm by pressing »OK/i«.
r e
– Display e.g.: »My EQ«.
4
Select the desired option with »
firm by pressing »OK/i«.
5 Press »Menu« to end the display.
Listening­with­headphones
1
Connect the headphones to the »PHONES«
headphone jack (ø 3.5 mm).
– This switches off the loudspeakers.
Caution:
Excessive sound pressure from the earphones
7
or headphones can cause hearing loss.
FM­mode
For the best FM reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
Selecting­the­input­source­FM
1 Select the input source FM with »Mode/AL«.
– Display: the frequency of a FM radio station.
Selecting­stored­stations
1 Select the station you want using the preset
buttons »1« to »5« (presets 1 to 5) or using
»5+­ ­ e II« and the preset buttons »1« to »5«
(presets 6 to 10).
10­ ­ ENGLISH
------------------------------------------------------------------------------------------------------------------------
Settings«
option »E Q «
­
« and con-
r e
Displaying­RDS­station­informations
RDS (Radio Data System) is an information sys-
tem which is transmitted additionally by most FM
stations.
Notes:­
It may take some time before all RDS infor-
7
mation is available.
GRUNDIG has no influence on the correct-
7
ness of such information.
1 Press »OK/i« repeatedly.
– The following display appears in succesion:
The name of the radio station, radio text (if
offered), station type (PTY), the current time
and date.
with
Listening­to­an­external­source
1 Use a standard audio cable to connect
IN« on the back of the device to an AUDIO
OUT socket on the external equipment.
2
Press »ON/OFF« to switch on the device.
3
Select the input source for the external device
with »Model/AL«.
– Display: »AUX IN«.
4 Rotate volume knob to adjust the volume .
5 Start playback on the external device.
Note:­
If no audio signal is available on socket
7
»AUX­IN«, the device switches automatical-
lyto Stand-by mode after 15 minutes. Forfur-
ther use switch on the device again.
»AUX­