Installing The Monitor; Choosing The Installation Location - Dometic M9Lq Bedienungsanleitung

M9LQ
7.2

Installing the monitor

!
CAUTION! Beware of injury
Select the location of the monitor so that it cannot injure the passengers in the
vehicle under any circumstances (e.g. sudden braking, road traffic accidents).
Observe the following installation instructions:
• Select an installation location that provides an unobstructed view of the
monitor (fig. 6 and fig. 7, page 4).
• Never install the monitor in areas where your head could hit it or in the airbag
deployment path. This could cause injury if the airbag opens.
• The monitor must not impair your vision when driving (fig. 8, page 4).
• The installation location should be flat.
• Check that there is sufficient space underneath the installation location to
attach the washers and nuts.
• Check beforehand that there is sufficient space on the other side for the drill
head to come out (fig. 2, page 4).
• Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
• Make sure you can lay the connection cable to the monitor.
• If possible, use original ducts for laying the connection cable or other suitable
options, such as ventilation grilles. If there are no existing ducts, you must drill
a hole of ∅ 17 mm. Check beforehand that there is sufficient space on the
other side for the drill head to come out (fig. 2, page 4).
7.2.1

Choosing the installation location

Proceed as follows (fig. b, page 7):
➤ Set the monitor on the monitor bracket and secure it with the knurled nut.
➤ Position the monitor with the attached monitor bracket provisionally.
➤ Mark the outlines of the monitor bracket on the dashboard.
➤ Take the monitor off the monitor bracket.
EN
Installing the LCD monitor
45