Dometic M9LQ Bedienungsanleitung Seite 48

Installing the LCD monitor
A
NOTICE!
Cables and connections that are not properly installed will cause malfunctions
or damage to components.
Correct installation of cables and connections ensures lasting and trouble-free
operation of the retrofitted components.
Observe the following instructions when laying the connection cable:
• To prevent damage to the cables, when laying them ensure that there is
always sufficient distance to vehicle components which can become hot
(lights, heaters, ventilators etc.).
• When laying the cables (fig. 3, page 4), make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection.
7.3.1 Connecting the monitor as a reversing video system
Proceed as follows (fig. d, page 8):
➤ Lay the monitor cable on the dashboard.
➤ Insert the plug (2) of the monitor cable in the socket (3) of the connection
cable (4) and secure them both.
A
NOTICE! Risk of damage
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black wires of the connection cable to a suitable voltage
supply:
– Connect the red wire (9) to terminal 15 (ignition).
– Connect the black wire (11) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the
brown wire (10) to the positive cable of the reversing light.
I
NOTE
If voltage is present in the brown wire (10), the reversing camera will be
activated automatically. The reversing camera has priority.
48
M9LQ
EN