Description Of The Appliance; Assembly - Kärcher K 4 Bedienungsanleitung

Description of the Appliance

The scope of delivery of the device (depending on the
model) is illustrated on the packaging. These operating
instructions describe all possible options.
Illustrations on Page 2
1 Coupling element for water connection
2 Quick coupling for high pressure hose
3 Storage for trigger gun
4 Water connection with integrated sieve
5 Appliance switch „0/OFF" / „I/ON"
6 Dosage regulator for detergent
7 Storage for trigger gun
8 Transport handle
9 Storage of Plug 'n' Clean detergent bottle with de-
tergent connection
10 Plug 'n' Clean detergent bottle with locking lid
11 Storage for high pressure hose
12 Storage hook for mains connection cable
13 Storage for spray lance
14 Mains cable with mains plug
15 Transport wheel with wheel cap
16 Trigger gun
17 Lock trigger gun
18 Key to detach the high pressure hose from the trig-
ger gun
19 High pressure hose
20 Spray lance with pressure regulation (Vario Power)
Carrying out the most common cleaning tasks. The
work pressure can be stagelessly regulated be-
tween "Min" and "Max". You can add detergent
when "Mix" is selected.
In order to adjust the working pressure, release the
lever of the trigger gun and turn the spray lance to
the desired position.
21 Spray lance with Dirtblaster
For strong contaminations
* Optional
22 Rotary washing brush
Especially suitable for cleaning cars.
23 Foam nozzle with detergent container
With powerful foam for effortless cleaning.
** Additionally required
24 Fabric-reinforced water hose with commercially
available coupling.
– Minimum diameter, 1/2 inches (13 mm).
– Minimum length 7.5 m.
12
Mount loose parts delivered with appliance prior to start-
up.
Illustrations on fold-out pages!
Install the storage for trigger gun
Illustration
 Place the bottom holder into the recesses and push
forward until it audibly locks in.
 Insert the top holder and push down all the way.
Install the transport handle
You will need the 2 included screws as well as a Phillips
screwdriver PH 2.
Illustration
 Slide the transport handle into the guide and se-
cure it with 2 screws.
Install the dosage regulator for detergent
You will need the 2 included screws as well as a Phillips
screwdriver PH 2.
Illustration
 Insert both detergent hoses onto the hose fittings.
Illustration
 Install the dosage regulator and connect using 2
screws.
Note: During installation you must make sure that
the tongues of the dosage regulator match up with
the intended recesses in the casing.
– 6
EN

Assembly