OPERATION
Generalfunctions
Switchingonandoff
1
Press »ON/OFF« to switch the device on and
off.
Adjustingthevolume
1
Adjust the volume using »
DABmode
For the best DAB reception, simply direct the wire
antenna accordingly.
SelectingtheinputsourceDAB
1
To select DAB radio as input source, press
»MODESCANALARM« for a short time.
– Display: »DAB«, then the name of a DAB ra-
dio station.
Selectingstoredstations
1
Select the station you want by using the preset
buttons »1,2,3,4,5« (presets 1 to 5) or using
»+5« and the preset buttons »1,2,3,4,5«
again (as changed to presets 6 to 10);
or
select the desired station from the station list.
DisplayingDABstationinformation
1
To display information on the current DAB sta-
tion, press »SELECT/INFO« repeatedly.
– The following display appears in succession:
Information from the provider (e.g. actual
broadcast, title of the song, e-mail address),
signal strength, genre, current frequency, refer-
ence to signal interference (at optimum signal
display »ERR: 0«), bit rate, broadcasting for-
mat, current time and date.
22
ENGLISH
------------------------------------------------------------------------------------------------------------------------------
+
VOL.–«.
SettingDynamicRangeControl
(DRC)forDABstations
When you activate Dynamic Range Control, you
can hear lower sounds better in a loud environment.
1
Open the menu with »MENU«.
2
Select the option »DRC« with »+VOL.-« and
press »SELECT/INFO« to confirm.
– Display: »DRC OFF«.
3
Select the option "DRC LOW" or "DRC HIGH"
with »+VOL.-« and press »SELECT/INFO« to
confirm.
4
Press »MENU« to end the display.
Note:
The DAB station must support DRC.
7
FMmode
For the best FM reception, simply direct the wire
antenna accordingly.
SelectingtheinputsourceFM
1
To select FM radio as input source, press
»MODESCANALARM« for a short time.
– Display: »FM«, then the frequency of a FM
radio station.
Selectingstoredstations
1
Select the station you want by using the preset
buttons »1,2,3,4,5« (presets 1 to 5) or using
»+5« and the preset buttons »1,2,3,4,5«
(as changed to presets 6 to 10).
DisplayingRDSstationinformations
RDS (Radio Data System) is an information sys-
tem which is transmitted additionally by most FM
stations.
Notes:
It may take some time before all RDS infor-
7
mation is available.
GRUNDIG has no responsibility for the ac-
7
curacy of such information.
1
Press »SELECT/INFO« repeatedly.
– The following display appears in succesion:
radio text (if offered), station type (PTY),
name of the radio station, current time and
date.