POWERSUPPLY/INSTALLATION
Connectingtothemainssupply
Note:
Check that the mains voltage on the type
7
plate (on the bottom of the device) corre-
sponds to your local mains supply. If this is
not the case, contact your specialist dealer.
1
Plug the power cable into the socket (230 V ~ ,
50/60 Hz).
Caution:
The device is connected to the mains with the
7
power cable. Pull out the power cable when
you want to disconnect the device from the
mains.
Make sure the power plug is easily acces-
7
sible during operation and not hindered by
other objects.
18
ENGLISH
-------------------------------------------------
Settingupthedevice
The speaker of the device is located at the bottom
of the device. To optimise the sound, mount the
device holder on the bottom of the device.
1
Click the device holder in place in the recesses
on the bottom of the device.
Mounting the device under the
cabinet
The fixing screws can be found in the side com-
partment of the packing.
1
Mark the locations for four mounting screws.
2
Screw the device holder under the cabinet with
four screws.
3
Insert the device in the holder.
Note:
To remove the device, press the snap-catch
7
at the back and remove by pulling forwards.
VOL.
VOL.