Power Supply; Mains Operation; Environmental Note - Grundig RRCD 1400 Handbuch

POWER SUPPLY

Mains operation

Check that the mains voltage on the type plate
(on the bottom of the device) corresponds to your
local mains supply. If this is not the case, contact
your specialist dealer.
1 Plug the power cord supplied into the
socket of the device.
2 Plug the power cord into the wall socket.
Note:
The batteries are switched off during mains
7
operation.
Caution:
The device is connected to the mains with the
7
power cord. Pull out the power plug when
you want to completely disconnect the de-
vice from the mains.
Make sure the power plug is easily acces-
7
sible during operation and not hindered by
other objects.
---------------------------------------------------------------------------------------------------------------
Battery doperation
1 Open the battery compartment by pressing
down on the mark underneath the device and
sliding the lid down.
»AC ~ «
2
Insert six batteries (6 x 1.5 V, type R20/
UM1/D size), observing the polarity marked
in the battery compartment.
3
Close the battery compartment.
Notes:
Do not expose the batteries to extreme heat,
7
caused for example by direct sunlight, heat-
ers or fire.
Remove the batteries when they are flat or
7
when you know that the device will not be
used for a long period of time. The manufac-
turer accepts no liability for damage caused
by leaking batteries.

Environmental note:

Batteries, including those which do not con-
7
tain heavy metal, should not be disposed of
with household waste. Always dispose of
used batteries in accordance with local en-
vironmental regulations.
ENGLISH
19