Operation Without External Control; Interconnecting Several Show Lasers (Master/Slave Operation) - EuroLite LED PUS-6 Bedienungsanleitung

Operation without External Control

► Automatic Mode
In automatic mode, various show programs are available that run at an adjustable speed.
1
Press the button MODE so many times until Aut is indicated in the display. Confirm with the ENTER
button.
2
Use the buttons UP and DOWN to select the desired program mode: AutP = flower LEDs, AutF =
strobe LEDs, AutL = laser or AutM for a combination of all light effects. Confirm with the ENTER
button.
3
Use the buttons UP and DOWN to select the number of the desired program.
4
Confirm with the ENTER button. The display indicates menu item running speed.
5
Use the buttons UP and DOWN to adjust the running speed of the program from S 1 (fast) to S 99
(slow).
6
Confirm with the ENTER button.
► Sound control
Via the microphone, which is integrated in the control unit the light set can perfectly reproduce the 37 show
programs to the rhythm of the music (sufficient bass provided).
1
Press the button MODE so many times until Sou is indicated in the display. Confirm with the ENTER
button.
2
Use the buttons UP and DOWN to select the desired program mode: SouP = flower LEDs, SouF =
strobe LEDs, SouL = laser or SouM for a combination of all light effects. Confirm with the ENTER
button.
3
Use the buttons UP and DOWN to select the number of the desired program.
4
Confirm with the ENTER button.
5
Adjust the microphone sensitivity to the volume of the music with the control SENSITIVITY. The LEDs
and the laser will be switched off after 5 seconds if the volume is too low or if there is no sufficient bass
beat.

Interconnecting Several Show Lasers (Master/Slave Operation)

Several show lasers may be interconnected (max. 32). Then all slave units can be synchronized and
controlled with the master unit without the need for a DMX controller. The units must be set to the
corresponding operating modes.
► Slave Units
Configure all slave units before connecting the master unit.
1
Press the button MODE so many times until SLA is indicated in the display.
2
Confirm with the ENTER button. The display will indicate SLAV and continue to flash until control
signals are being received from the master unit.
3
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX
controller to the DMX input of the master unit.
► Master Unit
Set the master unit to the desired show program (automatic mode or sound-controlled mode). The
interconnected light sets will now operate in sync.
www.eurolite.de
31