Operation Without External Control; Master/Slave Operation With Several Show Lasers - EuroLite LED FE-1500 Bedienungsanleitung

Operation without External Control

In automatic mode, 7 show programs are available that run at an adjustable speed or sound-controlled via
the built-in microphone if desired.
No. Description
0 Laser + color LEDs + white strobe LEDs
1 Laser + color LEDs
2 Laser + white strobe LEDs
3 Color LEDs + white strobe LEDs
4 Color LEDs
5 Laser
6 White strobe LEDs
► Automatic Mode
1
Press the button MENU so many times until
2
Use the buttons UP and DOWN to select the number of the desired program.
3
Confirm with the ENTER button. The display indicates menu item running speed.
4
Use the buttons UP and DOWN to adjust the running speed of the program from S 0 (fast) to S 100
(slow).
5
Confirm with the ENTER button.
► Sound control
1
Press the button MENU so many times until
2
Use the buttons UP and DOWN to select the number of the desired program.
3
Confirm with the ENTER button.
4
Adjust the microphone sensitivity to the volume of the music with the control SENSITIVITY. The LEDs
and the laser will be switched off after 5 seconds if the volume is too low or if there is no sufficient bass
beat.

Master/Slave Operation with Several Show Lasers

When several show lasers are interconnected (chapter 6), the slave units can be synchronized and
controlled with the master unit. The units must be set to the corresponding operating modes.
1
Set all slave units to slave mode: Press the button MENU so many times until
display. Confirm with the ENTER button.
2
Set the master unit to the desired show program. The interconnected show lasers will now operate in
sync.
www.eurolite.de
is flashing in the display.
is flashing in the display.
25
is flashing in the