Battery Removal - AEG Protect Home 600 Betriebsanleitung

5.11

Battery removal

Disconnect all power sources before battery replacement.
Follow Fig. 1 below to remove the screws located on the
bottom of the UPS to open the battery cover.
After removing the battery cover, gently extract batteries from
the case. Follow Fig. 2.
Disconnect the two connecting wires from the batterie and
replace with the same battery type (Fig. 3)
Replace the batteries following the inverse sequence.
Take care to connect the "+" and "-" poles correctly.
Battery replacement should be performed by
qualified service personnel.
Keep unauthorized persons away from the
batteries!
38
Fig. 1
Fig. 2
Fig. 3
EN