Troubleshooting - HMM Diagnostics Smart LAB pressure Bedienungsanleitung

Troubleshooting

Problem
Display will not light
up
LCD is dark / shows
„LO"
Display shows „E 01"
Display shows „E 02"
Display shows „E 03"
Display shows „E 10"
or „E 11"
Display shows „E 20"
Display shows „E 21"
Display shows „EExx"
Display shows „out"
Cause
Batteries are exhausted
Batteries are inserted incorrectly
AC Adapter is inserted incorrectly Replace the AC adaptor tightly
Battery too weak
Cuff is not secure
Cuff too tight
The pressure of the cuff is excess Relax for a moment and then measure
The monitor detected
motion,talking or the
pluse is too poor
while measuring.
The measurement
process does not
detect the pulse
signal.
The treatment of the
measurement failed.
A calibration error
occurred. (X can
be some digital symbol,
such as 1, 2,etc., if
this similar situation
appear, all belong to
calibration error.)
Out of measurement
range
Remedy
Replaxe with new batteries
Insert the batteries correctly
Insert new batteries
Refasten the cuff and measure again
Reapply cuff and start the measurement
again
again
Movement can affect the
measurement.Relax for a
moment and then
measure again.
Loosen the clothing on
the arm and then
measure again.
Relax for a moment and
then measure again.
Retake the measurement.
If the problem persists,
contact the retailer or our
customer service
department for further
assistance.Refer to the
warranty for contact
information and return
instructions.
Relax for a moment.
Refasten the cuff and then
measure again. If the
problem persists, contact
your physician.
55