Connecting The Appliance; Switching On The Appliance; Selecting The Temperature; Operating Tips - Bosch GSN Serie Gebrauchsanleitung

en
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with
a 10 A fuse or higher.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may
be replaced by an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or
to power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
20
Switching on
the appliance
Press button Fig. 2/1. Temperature
display lamp -18 °C. The 5 alarm"/"
display lights up. The appliance starts to
cool.

Selecting the temperature

The freezer compartment temperature is
set in the factory to -18 °C.
The set values can be changed, see
description of the control panel: Fig. 2/2
adjustment button.
We recommend a setting of -18 °C.

Operating tips

S When the freezer compartment has
reached its operating temperature,
the alarm display 5 goes out.
S The sides of the housing are sometimes
heated slightly. This prevents
condensation in the area of the door
seal.
S If you cannot open the freezer
compartment door immediately after
closing it, wait 2 3 minutes until the
partial vacuum has equalised.
S The fully automatic Nofrost system
ensures that the freezer compartment
remains free of ice. Defrosting is no
longer required.
l