Connecting The Appliance; Switching On The Appliance; Setting The Temperature - Bosch GSD Serie Gebrauchsanleitung

Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with
a 10 A fuse or higher.
If the appliance is to be operated
in a non European country, check
on the rating plate whether the
indicated voltage and current type
correspond to the values of your
mains supply.
The rating plate is situated in the
bottom left hand side of the appliance.
The mains connection cable may
be replaced by an electrician only.
Warning!
!
Never connect the appliance
to electronic energy saver plugs or
to power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
Switching ON the
appliance
Press the master switch Fig. 5/2, the
green and red pilot lights switch ON (not
all models). Warning signal is emitted (not
all models).
Switching OFF the warning
signal
(not all models).
Press the warning signal OFF button
Fig. 5/4. To ensure that the warning
signal is emitted in the event of a
malfunction, wait until the red pilot light
has gone out and then press the
warning signal OFF button again.

Setting the temperature

Set the temperature with the temperature
selector Fig. 5/1. Higher settings indicate
lower temperatures. We recommend a
medium setting (e.g. 2-3).
If your appliance features a temperature
display, adjust the temperature selector
until the temperature indicator is in the
black area Fig. 7.
Tips
S If the door cannot be opened
immediately after closing the freezer
compartment, please wait 2-3 minutes
until the partial vacuum has equalised.
S The refrigeration system may cause
parts of the freezer shelves to become
quickly covered in hoarfrost. This will
NOT affect the function or power
consumption of the appliance.
en
23