Installation; Installation Location; Aligning The Appliance; Changing Over The Door Hinges - Bosch GSD Serie Gebrauchsanleitung

en

Installation

Installation location

Install the appliance in a dry, well
ventilated room. The appliance should
not be installed in direct sunlight or near
a heat source such as a cooker, radiator,
etc. If installation next to a heat source
is unavoidable, use a suitable insulating
plate.
Observe the following minimum distances
to heat sources:
S 3 cm to electric or gas cookers.
S 30 cm to an oil or solid fuel cooker.
If installing the appliance next to another
refrigerator or freezer, there must be
a minimum gap of 2 cm between
the appliances in order to prevent
condensation.

Aligning the appliance

Fig. 2/A
The appliance must be level. If the floor
is uneven, use the front height adjustable
feet.
20
Changing over the door
hinges
d
Warning
While changing over the door hinges,
ensure that the appliance is not
connected to the power supply.
Pull out the mains plug beforehand.
Tilt back the appliance (if required, place
packaging material, etc. underneath).
Fig. 3
The door hinges can be changed over
if required by the installation location.
Proceed in numerical sequence.
Installing appliance
under worktop
After removing the worktop, the appliance
can be installed under a worktop.
Fig. 1
Removing the worktop
S Unscrew screws at the rear
of the worktop.
S Lift worktop slightly and remove.
Appliance ventilation
A ventilation cross section of
2
minimum 160 cm is necessary for
installation below a worktop. For this
purpose, a vent measuring about
500 x 60 mm is required, which is
available from DIY shops or specialist
retailers.
S Mark the cut out for the vent on
the worktop centric to the appliance.