Control Panel; Note Ambient Temperature And Ventilation - Bosch GSD Serie Gebrauchsanleitung

en

Control panel

Fig. 5 A/B
1 Temperature selector
To set the temperature, rotate the
temperature selector with a coin.
Position 1" hottest temperature,
Position 7" coldest temperature
2 On/Off button
with green pilot light (lights when the
master switch has been switched
ON).
3 Fast freeze button with yellow pilot
light
(lights when fast freeze has been
switched ON). To switch OFF, press
the fast freeze button again
(fast freeze does NOT switch OFF
automatically).
4 Temperature warning light (red)
Lights if the freezer compartment is
too warm, i.e. the frozen food is at risk
of thawing. This warning light does
not always indicate that the food is at
risk, as it may switch ON temporarily
when the appliance is switched ON,
when large quantities of fresh food
have been placed in the freezer, when
the appliance door has been open for
too long or when the temperature
selector has been set to a higher
setting (lower temperature).
5 Warning signal OFF button
(not all models)
The warning signal is emitted at the
same time as the red warning light
switches ON. The warning signal
stops when the red warning light goes
out or when the warning signal OFF
button is pressed.
22
Note ambient
temperature and
ventilation
The climatic class can be found on the
rating plate. It specifies the ambient
temperatures at which the appliance may
be operated. The rating plate can be
found inside the appliance at the bottom
left hand side.
Climatic category Permitted ambient
temperature
+10 °C to 32 °C
SN
+16 °C to 32 °C
N
+18 °C to 38 °C
ST
+18 °C to 43 °C
T
Ventilation
Fig. 6
The air at the back of the appliance will
heat up. This warm air must be allowed to
freely escape, otherwise the refrigerating
machine must perform more. This raises
electricity consumption. Hence, the
air inlet and outlet apertures should never
be covered or blocked off!