SATA SATAgraph 1 Betriebsanleitung Seite 9

Operating Instructions SATAgraph 1
Preface
Prior to putting the unit/paint spray gun into operation, read the operating instructions comple-
tely and thoroughly. The stipulations contained therein are to be respected in any case. After
that, the operating instructions are to be stored in a safe place, accessible for every user of the
equipment. The unit/paint spray gun may only be put into operation by persons familiar with its
use. Inappropriate use of the unit/paint spray gun, modification of any kind or combination with
inappropriate other parts may cause material damage, serious hazard to the user's, other person's
or animal's health or even death. SATA shall not take any responsibility for such damages (e.g.
failure to respect the stipulations laid out in the operating instructions). The applicable safety,
workplace and worker health protection regulations of the respective country or area/district in
which the system/the paint spray gun is used are to be respected in any case (e.g. the German
Rules for the Prevention of Accidents BGR 500 (BGV D25) and BGV D24 issued by the Central
Office of the Professional Trade Associations, etc.).
To be noted
Never point paint spray guns at yourself, at other persons or animals. Solvents and thinners can
cause burns. Only the respective quantities of solvents and paints required for work progress may
be present in the direct surroundings of the unit (after work, solvents and paints are to be returned
to their assigned storage rooms). Prior to any repair work the unit must be disconnected from the
air supply. Prior to putting the unit into operation, especially after each cleaning and each
repair work, check all screws and nuts for tight fit, as well as the sealing performance of
the spray guns and hoses. Defective components must be replaced or repaired accordingly. To
obtain best possible coating results, and for maximum safety, only use original spare parts. No
sources of ignition (e.g. open flames, burning cigarettes, lamps without ex-protection etc.) may be
present during painting, as easily flammable mixture are generated during the painting process.
Occupational safety regulations must be applied when painting (respiratory protection, etc.). No
vibration is transmitted to the upper parts of the operator's body during use of the paint spray
gun. Recoil forces are negligible. The use of this product in explosion hazard areas Zone 0
is prohibited.
SATA, the SATA Logo and/or other SATA products referenced herein are either registered trade-
marks or trademarks of SATA GmbH & Co. KG in the U.S. and/or other countries. The names of
companies and products mentioned herein may be the trademarks of their respective owners.
1. Features and technical data
1.1. Gravity flow cup version
• Gun with nozzle 0.25
• 2.5 ml gravity flow cup with lid
• Replacement "O" ring for paint nozzle
• Weight: approx. 94 g
• Operating pressure between 1.0 and 3.0
bars (14 to 43 psi)
• Recommanded un inlet pressure
2.5 bars (35 psi)
• Max. gun inlet pressure 4 bars
(58 psi)
II.1