Troubleshooting; Warranty - Kärcher PUZZI 30-4 Bedienungsanleitung

 Replace the flat pleated filter at least
every 12 months with normal use, re-
place earlier as necessary.
Note: The flat pleated filter must be dis-
posed of in the residual waste.
Clean the fluff filter
 Unlock the bonnet, swivel it upwards
and snap it in place at the locking devic-
es.
 Unlock and remove the filter casing.
 Take out the flat folded filter.
 Unscrew the swimmer.
 Clean the fluff filter.
Cleaning the fresh water sieve
 Unscrew the fresh water sieve incl. the
lid.
 Clean the fresh water sieve.
Cleaning the nozzle
 Unscrew the covering nut.
 Clean nozzle mouthpiece.

Troubleshooting

DANGER
– Danger of injury by electric shock.
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
– Get the electrical components checked
and repaired only by authorised cus-
tomer service persons.
Appliance is not working
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
 Turn on the appliance.
Device is not sucking in detergent
 Clean the fresh water sieve.
 Check the spray hose.
Insufficient working pressure
 Clean or replace nozzle tip.
18
Spray stream one-sided
 Clean nozzle mouthpiece.
Insufficient vacuum performance
 Check the bonnet for proper seating.
 Clean the seal of the bonnet and the
seating on the wastewater container.
 Clean the fluff filter.
 Check suction hose for blockages;
clean if required.
 Check the swimmer.
 Check for proper installation of the flat
pleated filter.
 Clean the flat pleated filter, replace if
necessary.
 Allow the flat pleated filter to dry, or in-
sert a new, dry flat pleated filter.
Swimmer is interrupting the suction
 Empty the wastewater reservoir.
 Prevent foam generation when adding
detergent RM 761 to the wastewater
container.
 Reduce the formation of foam by using
the defoaming agent dosing unit (op-
tional accessory).
Customer Service
If malfunction can not be fixed, the de-
vice must be checked by customer ser-
vice.
The warranty terms published by the rele-
vant sales company are applicable in each
country. We will repair potential failures of
your appliance within the warranty period
free of charge, provided that such failure is
caused by faulty material or defects in man-
ufacturing. In the event of a warranty claim
please contact your dealer or the nearest
authorized Customer Service centre.
Please submit the proof of purchase.
– 6
EN
air flow

Warranty