The Remote Control System; Operating The Remote Control - Gm-Racing 90503 Bedienungsanleitung

Montage hinteres Differenzial
Rear differential Assembly
Assemblage différentiel arrière
23 GM-Racing 90503.RTR Nitroquad 2WD
TOOLS
In addition to the tool that accompanied the vehicle, the following tools are useful and - in some cases -
necessary:
• Small fl at and small Phillips screwdriver e.g. No. 5781.3 and 5779.1
• Needle nose pliers
• Glow-Plug Screwdriver
• Hex wrench with 1.5 mm, 2 mm and 2.5 mm
Modellbaukraftstoff Tankflasche
Glühkerzenstecker
Glow Fuel Fuel bottle
Carburant Bidon de remplissage
Glow Igniter + Charger
Soquet de démarrage

THE REMOTE CONTROL SYSTEM

In the vehicle the GM-Racing XG-6 Sport Spec is inserted. For this remote control a separate manual is at-
tached.
Running multiple vehicle
If you have a vehicle of your and your friends with other vehicles that you will be racing with, it is very im-
portant that you fi rst check what frequency channel your vehicle is on and confi rm that none of your friends
have the same frequency as yours. If you do fi nd that someone else is using the same frequency channel
that you are, you must wait for them to turn their transmitter and vehicle OFF or you may choose to change
the frequency crystals in your transmitter and receiver (so that you can run together at the same time without
causing any radio interference). Additional frequency crystal sets can be purchased separately and installed
in a few quick seconds. To change frequency crystals simply remove the black plastic crystal holder from the
back of your transmitter by carefully pulling it straight out. Slide the crystal out of the holder and install the
new crystal labelled „Tx" in its place. Then carefully align the two pins that extend from the transmitter, and
gently press it into place. DO NOT force the crystal! The pins can easily be broken! Remove the crystal from
your receiver in the same careful manner using a pair of needle-nose pliers and install the new „Rx" crystal
in its place.
PLEASE NOTE: It is very important that the crystal labelled „Tx" is installed in the transmitter and the crys-
tal marked „Rx" is installed in the receiver.

OPERATING THE REMOTE CONTROL

• Run your Nitroquad never with low transmitter or receiver batteries.
• Never forget switch off the radio after running your Nitroquad, otherwise the batteries do not last long.
• Turn on the transmitter fi rst, then the vehicle.
• After driving fi rst turn off the vehicle, then the transmitter.
• For optimal use fi rst check the steering and throttle trim positions:
Steering Trim
The Nitroquad should go straight without turning the steering wheel. If not, rotate the Steering Trim knob in
the direction needed for the vehicle to go straight.
Throttle/Brake Trim
Let the throttle in neutral position and push the vehicle on the ground a little. It must be easy to roll. Now
press the brake, the vehicle should stop immediately. If not, rotate the Throttle Trim knob right of the steering
wheel in the direction needed.
GM-Racing 90153.RTR Nitroquad 2WD
(mit Ladegerät)
(avec chargeur)
Sonstiges Werkzeug - Additional tools - Outillage divers
08