Maintenance - Fryka TS 50-100 Betriebsanleitung

Maintenance

7 Maintenance
7.1 Defrosting
First empty the freezer interior then switch it off as described. Then pull out the power cord. Open the freezer,
and leave it in this state until the ice in the interior has defrosted. Remove the condensation water. You thereby
prevent mould and bacteria formation. You can additionally disinfect the interior. Pay attention especially to
drying in the seal area. The defrosting frequency depends on the use and frequency of opening. In any case,
defrost the freezer when there is severe icing in the seal area. Operation is restarted as described.
W
ARNING

Never clean or defrost the freezer using a steam-cleaning unit! The steam can come into contact with
electric parts and trigger a short circuit. A risk of fire and electric shock!
7.2 Refrigeration unit
Clean the fin coil heat exchanger of the freezer every six months whatever the degree of soiling at the installation
site.
N
OTE

A soiled fin coil heat exchanger results in overheating and outage of the freezer!
C
AUTION

Avoid direct contact with the fin coil heat exchanger – the fin coils are sharp-edged. Danger of cuts!
Switch off the freezer as described and pull out the mains power plug. Releasing the fastening screws on the left
side of the freezer, and remove the grille. Clean the black fin coil heat exchanger with compressed air or using a
brush/vacuum cleaner. Replace the grille.
Other components of the freezer are designed for continuous operation and do not require any maintenance.
66 // 74