Installation And Set-Up; Switch On The Freezer - Fryka TS 50-100 Betriebsanleitung

4

Installation and set-up

4.1 Install the freezer
W
ARNING

Fire and electric shock risks due to moisture. If current-carrying parts or the power cord become moist, a
short circuit may occur. The unit is designed for use in enclosed rooms. Do not operate the unit outside or in
areas moist or splashed with water.
The freezer is suitable for installation only in dry and ventilated/air-conditioned rooms. Heed the permissible
ambient temperature
(Chapter "
sunshine or be near a source of heat such as radiators.
Install the freezer on a flat surface.
N
OTE

Do not operate the unit in a tilted position. The refrigeration unit may otherwise fail to work.

Too much heat at the installation site may have the same effect.
Install the freezer in such a way as to ensure optimum ventilation. Maintain a distance of at least 30 cm from the
ventilation grille to the nearest object (wall, etc.).
4.2 Connect the freezer
Wait at least one hour after connecting the freezer before starting it up. Check the unit for damages each time
before starting the freezer up. Only connect the freezer to a properly installed socket with earthing contact. The
socket may be earthed with a maximum 16A slow-to-blow earth.
N
OTE

Operate the freezer only with the mains voltage, current and frequency indicated on the rating plate. Not
heeding the instructions may cause the unit to malfunction or cause defects.
W
ARNING

Do not use any extension cords or distributor banks. A risk of fire and overheating.
4.3

Switch on the freezer

Before switching it on, make sure that the sealing of the door is dry and clean.
N
OTE

Empty the interior before you switch on the freezer. Starting with the interior full may cause overloading and
a shutdown of the refrigeration unit.
Press the "on/off" key to switch on the freezer. After a few seconds, the control displays the main screen with the
current and desired temperatures in the interior (Setpoint). You must press the "on/off" for at least two seconds
for the command to be executed. This is to prevent unintentional pressing.
Technical data
" // see page 71). The freezer should not be left in direct
Installation and set-up
43 // 74