Master Address - Fryka TS 50-100 Betriebsanleitung

Control and operation
5.2.1.4.2 Plant name
5.2.1.4.3 Recording interval
If a shorter recording interval is selected, the recording duration is corresponding shorter until
there is no more memory capacity.
A few values are listed as examples below:
Measurement interval
60 sec.
120 sec.
300 sec.
600 sec.
900 sec.
If the memory capacity of the control is exhausted, the oldest values are overwritten to release
disk space for new data (circulating buffer).
5.2.1.4.4

Master address

56 // 74
Recording duration
= 1 minute 190 days
= 2 minutes 380 days
= 5 minutes 951 days
= 10 minutes 1902 days
= 15 minutes 2854 days
Assign or change the freezer name
using the screen keyboard.
The name is used for data export,
among other things.
The time between two measurement
points is the recording interval. You
can select it freely in the range
between 10 and 1500 seconds (25
minutes). Use the +/- buttons or the
slide controller to do this.
The interval is set of 120 seconds in
the ex-works state. This corresponds
to a recording duration of 12 months.
(approx. 1/2 year)
(approx. 1 year)
(approx. 2,5 years)
(approx. 5 years)
(approx. 8 years)
You can change the ST-BUS address of
control here. This is only required if
several freezers (Master) are to be
used in the same network. In this case,
different addresses must be assigned.
We recommend only using addresses
>247.