Alarm Management - Fryka TS 50-100 Betriebsanleitung

5.2.1.8 Alarm management

When you click the "Name" button, you can name your
configuration using the screen keyboard.
As soon as the error has been corrected and acknowledged, the e-mail recipients receive an e-mail again with
the status "resolved".
If no e-mails are sent despite correct settings, deactivate the selected recipient and then select him again. Save
your settings again.
You can define three different alarms in alarm
management. "Warning", "Alarm 1", and "Alarm 2".
You can set different e-mail recipients and alarm
events for each of these alarms to inform different
persons in the event of different alarms.
You define the alarms, for which an e-mail is sent,
when you press the "New" button. To do this, select a
control area and confirm by clicking "Save"
When you click the "Receiver" button, you can select
from the e-mail addresses defined
" E-mail configuration " // see page 58).
You can activate various alarm messages for e-mail
transmission; then an e-mail is sent when they occur.
(Icon inactive-active)
Sensor break
Sensor short circuit
Interior temperature too warm
Interior temperature too cold
By clicking the button in the upper right corner, you
can set an alarm delay up to 99 minutes. Then an e-
mail is sent only if the corresponding alarm is longer
than the duration set on the unit here.
Control and operation
above (Chapter
63 // 74