Skywalk CAYENNE4 Handbuch Seite 51

> Fold over the gathered cloth from the bottom up, pressing the air out as you go fold
the complete cell over once towards the middle>repeat the same packing method
on the other glider half.
> Now lay both sides on top of one another and make sure that the leading edge rein-
forcements lay neatly on top of one another.
> Fold the cells from the bottom in the direction of the leading edge, the first fol should
have approximately the length from hand to elbow.
> The leading edge can be folded inward once from the upper end, but this is not total-
ly necessary. However, any air remaining inside the glider should be pressed out
> through the leading edge, and not through the material.l
> Now place the compression band around the glider across the leading edge
> Place the entire glider into the inner pack sack. This protects the glider from being
damaged by the zipper or other objects.
> open the pack sack and lay the glider inside. The soft material here provides for
good carrying comfort for your lower back.
> Now lay the harness with the seat board upwards onto the glider in the pack sack
and (in most cases), close with the zipper. The top of the packsack offers enough
space for helmet, overall, instruments, etc.
> Now lay the harness with the seat board upwards onto the glider in the pack sack
and (in most cases), close with the zipper. The top of the packsack offers enough
space for helmet, overall, instruments, etc.
The rods in the leading edge replace the well-known mylar and bring considerable ad-
vantages, especially with regard to the launch performance of your CAYENNE4. They
are resistant to bending and require no special handling. The same applies to the rein-
forcements above the C-connection points (C-wires).
tip: be careful that you do not pack your skywalk cayenne4 too tightly and
treat the leading edge area with special care. your wing will thank you with a
longer product life.
51