Acceleration System - Skywalk CAYENNE4 Handbuch

acceleratiOn SySteM

The skywalk CAYENNE4 can be equipped with a foot-operated speed system. The
speed system acts on the A-, and B-risers. All of the risers are the same length when
the speed system is not in use. Thanks to the 3-line system, the CAYENNE4 has very
efficient accelerator travel. The A- and B-risers shorten upon operation of the speed
system. Just how much can be seen from the drawing on page --.
installing the accelerator equipment:
Most commercially available harnesses have pulleys attached for the speed system.
The speed system lines are fed up through the pulleys on the harness and connected
42
with the brummel hook. With the correct adjust-
ment of the speed system lines, the first level of
the speed system can be easily accessed with
legs bent during flight, and the second level of
the entire trim is accessible with legs stretched
out. Before launch, the hooks (maillon or brum-
mel hook) must be attached from the foot speed
system to the speed system on the risers. Make
sure that the speed system lines runs freely.
A schematic diagram of the risers can be found
on page 64-66.