Original Accessories / Attachments; Before First Use; Fitting The Helical Spring; Inserting / Replacing Soldering Tips - Parkside PLBS 30 A1 Bedienungsanleitung

Original accessories / attachments

Q
Use only the accessories detailed in the operating instructions. The
use of attachments or accessories other than those recommended
here could lead to you suffering an injury.

Before first use

Q

Fitting the helical spring

Q
Insert the narrower end of the helical spring
of the multifunctional holder
end of the helix points upwards and insert it into the recess provid-
ed for it in the multifunctional holder
Push the helical spring
Turn the helical spring
holder in place.
7

Inserting / replacing soldering tips

Q
CAUTION! DANGER OF BURNS! Allow the soldering
pencil to heat up without a soldering tip.
Removal of a soldering tip
may only be done when the appliance has been switched off and
the soldering tip or attachment has cooled down.
All soldering tips and attachments have a screw thread and can,
therefore, be easily and quickly replaced on the soldering pencil
Turn the soldering tip or attachment anti-clockwise to remove it.
Turn the soldering tip or attachment clockwise to fix it in place.
Safety advice / Before first use
. Ensure that the outwardly bent
7
7
into the opening as far as it will go.
3
clockwise to fix the multifunctional
3
or a copper attachment
2
into the opening
3
(see arrow in Fig. B).
9 10 11
GB/IE/CY
.
1
13