Replacing The Light Bulb - Scholtes FP E6.1 GF S Bedienungsanleitung

3. (with glass panel fitted to the inside of the
door) Grip the door on the two outer sides
and close it approximately half way. Unlock
the door by pressing on the clamps F, then
pull the door towards you, lifting it out of its
F slot (see diagram).
To replace the door, reverse this sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.

Replacing the light bulb

Oven
compartment
Lamp
Seal (only on a
few models)
Glass door
! Do not use the oven lamp as/for ambient lighting.
Automatic cleaning using the PYROLYTIC cycle
During the PYROLYTIC cycle, the internal temperature of the oven reaches
500°C. When the pyrolytic cycle is activated, food and grime residues are
burnt away. Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause for concern: this process
is both normal and hazard-free.
Before initiating the PYROLYTIC cycle:
• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;
• remove all accessories;
• do not place tea towels or pot holders over the oven handle;
• turn the SELECTOR knob to the "0" position.
! If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to
cool down.
! The cycle may only be started once the oven door has been closed.
F
To replace the oven light bulb:
1. Remove the glass cover using a
screwdriver.
2. Unscrew the light bulb and
replace it with a similar one: Wattage
15 W, cap E 14.
Replace the glass cover, making
sure the seal is positioned correctly
(see diagram).
To activate the PYROLITIC cleaning cycle, press and hold the
for approximately 4 seconds. The SET TIME KNOB may be used to select
the desired cleaning level; there are three default time settings which cannot
be modified.
1. Economy (ECO): turn the knob towards " ". Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards " ". Duration 2 hours.
4. Press the button to confirm.
An end time for the PYROLITIC cycle (as for a normal cooking cycle) may be
programmed (see Programming the automatic cleaning end time).
Safety devices
• the icon on the display, when lit, indicates that the oven door was
automatically locked as soon as the temperature reached a high value;
• the icon indicates that the cleaning cycle may be cancelled
at any time by pressing the
• if a malfunction occurs, the heating elements will be switched off;
• once the oven door has been locked, you cannot change the duration and
cycle end time settings.
Programming the automatic cleaning end time
1. Press the button until the
the DISPLAY begin to flash.
2. Turn the SET TIME KNOB towards " " and " " to adjust the hour value.
3. Press the button again so that the other two numerical digits on the
DISPLAY begin to flash.
4. Turn the SET TIME KNOB towards " " and " " to adjust the minute value.
5. Press the button again to confirm.
6. When the set time has elapsed, the text END appears on the display and
a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy PYROLYTIC cycle has been
selected: default set duration 1 hour. 12:30 is scheduled as the end time.
The programme will start automatically at 11:30 a.m.
Programming has been completed when the
The DISPLAY shows the PYROLITIC cycle end time and duration alternately.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the oven has cooled down
sufficiently before you can open the oven door. You will notice some white
dust deposits on the bottom and the sides of your oven; remove these
deposits with a damp sponge once the oven has cooled down completely.
Alternatively, you can make use of the already heated oven, in which case it
is not necessary to remove the deposits, they are completely harmless and
will not affect your food in any way.
button
button;
icon and the two numerical digits on
and icons light up.
GB
29