Care And Maintenance; Switching The Appliance Off; Cleaning The Appliance; Cleaning The Oven Door - Scholtes FP 955.1 Bedienungsanleitung

Care and maintenance

Switching the appliance off

GB
Disconnect your appliance from the electricity
supply before carrying out any work on it.

Cleaning the appliance

• The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
! Never use steam cleaners or pressure cleaners on
the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could
scratch the surface and cause the glass to crack. To
clean more thoroughly, you can remove the oven door.
• Open the door fully and lift up the two small levers
"B";
• Now, when the door is closed slightly, it can be
lifted out by removing hooks "A" as shown in
figure.
To replace the door:
• With the door in an upright position, insert the 2
hooks "A" into the vents;
• Make sure that slot "D" is perfectly fastened to
the edge of the vent (move the door forwards and
backwards slightly);
• Keep the door completely open, shift the 2 levers
"B" downwards, then close the door.
24
Inspecting the seals
Check the door seals around the oven at regular
intervals. If the seals are damaged, please contact
your nearest Service Centre (see Assistance). We
recommend that the oven is not used until the seals
have been replaced.

Replacing the light bulb

Oven
compartment
Lamp
Seal
Glass door
1. Remove the glass cover using a screwdriver.
2. Unscrew the light bulb and replace it with a
similar one: Wattage 15 W, cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly (see diagram).

Assistance

Warning:
The appliance is fitted with an automatic diagnostic
system which detects any malfunctions.
Malfunctions are signalled through messages of the
following type: "F", followed by numbers.
Call for technical assistance in the event of a
malfunction.
! Never use the services of an unauthorised
technician.
Please have the following information to hand:
• the type of problem encountered;
• the appliance model (Mod.);
• the serial number (S/N).
The latter two pieces of information can be found on
the data plate located on the appliance.
To replace the
oven light bulb: