Selecting The Application Tool; Attach Sanding Sheet To Grinding Plate; Changing The Application Tool - Parkside PAMFW 10.8 A1 Betriebsanleitung

Selecting the application tool

Note: The universal system with easy tool change
fits common accessories.
HCS plunge saw blade 95 x 32 mm
Materials:
Wood, plastic, plaster and other soft materials
Use:
· Cut-off and plunge saw cuts
· sawing close to the edge, even in hard to reach
areas
Example: cutting notches in light construction walls.
(see Fig. A and B)
Diamond saw blade
Material:
Tile cement, Tile joints
Use:
· Removing material residue, for example tile
cement when replacing damaged tiles
· Reaming joints in wall- and floor tiles (see Fig. C)
Scraper
Materials: Motor / cement residue, tile / carpet
adhesive, paint/silicone residue
Use:
· Removing material residue, for example carpet
adhesive residue on floors (see Fig. D)
Grinding plate
Materials:
Wood and metal (sanding sheets included),
paint*, stone*
*depending on sanding sheet
Use:
· Sanding edges and hard to reach areas
(see Fig. E and F)
Attach sanding sheet to
grinding plate
S anding sheets
15
plate by means of the hook and pile fastening.
14

Changing the application tool

(see Fig. G)
DANGER OF INJURY!
Always remove the battery from the unit
before working on the power tool.
R emove any tool already inserted. To do this,
release the clamping screw
key and take off the tool.
10
P lace the tool (e.g. plunge saw blade
the tool mount.
NOTE: You can place the tool in any of the
possible positions on the tool mount.
F asten the tool in place with the clamping
screw and clamping plate.
7
Start-up
are attached to the backing
using the Allen
7
) on
13
GB/IE/CY 11