4 Do one of the following:
•
Select Capture.
•
Press the Quick Photo One-Touch Button (if configured).
•
Press the Start Camera One-Touch Button (if configured).
The picture is saved either in the internal memory or on a microSD card, depending on the radio
model.
4.5.2
Setting the Flash
When and where to use: Use this menu item to configure the flash settings and adjust them to
existing shooting conditions.
NOTICE: The flash intensity may be reduced if the battery level is low. If the battery level is too
low, the flash does not start at all.
Procedure:
1 From the home screen, press the Menu key.
2 Select Camera.
3 Press the Menu key and select Flash.
4 Select one of the following:
•
Automatic – the flash fires automatically when needed; for example, when lighting
conditions are poor.
•
On – the flash is enabled and fires each time a picture is captured.
•
Off – the flash is disabled.
NOTICE: If the radio is in the Cover Mode, the flash is always disabled (even if
Automatic or On options are selected).
4.5.3
Setting Picture Resolution
When and where to use: To configure the resolution in which the pictures are captured.
NOTICE:
The smaller resolution, the smaller picture size but the lower picture quality. The larger resolution, the
better picture quality but the bigger picture size.
Procedure:
1 From the home screen, press the Menu key.
2 Select Camera.
3 Press the Menu key and select Resolution.
4 Select one of the following:
•
Large – sets picture resolution to five megapixel.
•
Medium – sets picture resolution two megapixel.
•
Small – sets picture resolution to one megapixel.
Send Feedback
68015000663–CB (en-US)
Chapter 4: Main Menu
83