ENGLISH
Removing the residues and stubborn
residues
1. Food containing sugar, plastics, tin foil
residues should be removed at once,
best tool for cleaning glass surface is a
scraper (not included with the
appliance). Place a scraper on the glass
ceramic surface at an angle and remove
residues by sliding the blade over the
Troubleshooting
Warning! Refer to Safety
chapters.
What to do if...
Problem
The appliance cannot be ac-
tivated or is not operating.
The residual heat indicator is
not displaying anything.
There is no signal when you
touch panel symbols.
2. Limescale rings, water rings, fat
Possible cause
The appliance is not connec-
ted to an electrical supply or
it is connected incorrectly.
More than 10 seconds
passed since you activated
the hob.
The Child Safety Device is on
.
Several symbols were
touched at the same time.
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated. Activate the signals. Refer to
surface. Wipe the appliance with a
damp cloth and a little washing up
liquid. Finally, rub the appliance dry
using a clean cloth.
splashes, shiny metallic discolorations
should be removed after the appliance
has cooled down using cleaner for glass
ceramic or stainless steel.
Check if the appliance is cor-
rectly connected to the elec-
trical supply (refer to con-
nection diagram).
Activate the appliance
again.
Deactivate the Child Safety
Device (See the section
"Child Safety Device").
Touch only one symbol.
If the cooking zone is sup-
posed to be hot, call the Af-
ter Sales Service.
OffSound Control.
12
Remedy