Specifications; Standard Accessories - Hitachi WR 8DH Bedienungsanleitung

English
your hands or any other part of your body. You
could be cut or caught in the socket. Also, be
careful not to touch the socket after using
continuously it for a long time. It gets quite hot
and could burn you.
9. Never let the impact wrench turn without a load
when using the universal joint.
If the socket turns without being connected to a
load, the universal joint causes the socket to turn
wildly.
You could get hurt or the movement of the socket
could shake the impact wrench so much as to
make you drop it.
10. Always charge the battery at a temperature of 0
– 40°C.
A temperature of less than 0°C will result in over
charging which is dangerous. The battery cannot
be charged at a temperature greater than 40°C.
The most suitable temperature for charging is that
of 20 – 25°C.
11. Do not use the charger continuously.
When one charging is completed, leave the charger
for about 15 minutes before the next charging of
battery.
MODEL
WR8DH: with charger and case

SPECIFICATIONS

POWER TOOL
Model
No-load speed
Capacity
Tightening torque
Rechargeable EB9B (2.0 Ah)
battery EB9H (2.2 Ah)
Weight
CHARGER
Model
Charging time
Charging voltage
Weight

STANDARD ACCESSORIES

1. Charger (UC14YF2) ................................................... 1
2. Plastic case ................................................................ 1
Standard accessories are subject to change without
notice.
5
WR8DH
0 – 2200/min
M6 – M14 (Ordinary bolt)
M6 – M10 (High tension bolt)
Maximum 1000 kg-cm
Tightening is M14 high tension bolt (strength grade 12.9), when
fully charged at 20°C temp. Tightening time: 3 sec.
Ni-Cd battery, 9.6 V
Ni-MH battery, 9.6 V
1.6 kg
UC14YF2
EB9B Approx. 60 min. (at 20°C)
EB9H Approx. 70 min. (at 20°C)
7.2 – 14.4 V
1.3 kg
12. Do not allow foreign matter to enter the hole for
connecting the rechargeable battery.
13. Never disassemble the rechargeable battery and
charger.
14. Never short-circuit the rechargeable battery.
Short-circuiting the battery will cause a great
electric current and overheat. It results in burn or
damage to the battery.
15. Do not dispose of the battery in fire.
If the battery burnt, it may explode.
16. Do not insert object into the air ventilation slots
of the charger.
Inserting metal objects or inflammables into the
charger air ventilation slots will result in electrical
shock hazard or damaged charger.
17. Bring the battery to the shop from which it was
purchased as soon as the post-harging battery life
becomes too short for practical use. Do not dispose
of the exhausted battery.
18. Using an exhausted battery wil damage the
charger.